Road Rejuvenation…saves money, saves time, saves disruption, saves the environment

The right product to the right road at the right time
An asphalt rejuvenator is a manufactured product with the ability to absorb into the pavement or road to restore those reactive components that have been lost due to oxidation. It extends the useful life of asphalt pavements and roads and thereby lowers the annual resurfacing costs as well as future resurfacing costs.

"With the Right Care the Miles Don't Show"

The Rejuvenation Process The damaged surface area is: Thoroughly cleaned Pre-tested to determine application rate Ready for crack sealing and infrared repairs Sprayed with Reclamite® or CRF® Left to dry (usually open to traffic within the hour!) Dusted to increase grip and road safety Ready for use Reclamite® PDF - Click to Download

Asphalt Rejuvenators can be a maintenance department’s lowest-cost surface treatment for extending pavement life.

Crack sealing and infrared repairs are made to damaged areas before treatment. CRF® rejuvenating sealer is used if aggregate is dislodged, it acts as a mortar by locking in the stones and preventing any further stone loss, as well as sealing out air, water and sunlight.

The Reclamite® rejuvenating agent penetrates into the voids and migrates throughout the asphalt road surface. Using the Reclamite® rejuvenating agent means that in some cases road marking renewal is not always necessary, saving your budget, saving time, saving disruption. If an area is not suitable to be sprayed with the large distributer truck, then a hand operated spray wand can be used in those areas.

Reclamite stops pavement deterioration where it begins, "AT THE TOP". Asphalt cement is made up of asphaltenes and maltenes to provide the physical characteristics needed for a good asphalt pavement. Weather and Ultraviolet rays from the sun damage the maltene fraction of the asphalt causing the pavement to become dry and brittle. The resulting loss of aggregate, cracking and moisture intrusion furthers pavement deterioration that will eventually, without intervention, will lead to total pavement failure. Pavements exhibiting early signs of aging (minor hairline cracking, moderate raveling, and pitting) are excellent candidates for Reclamite Preservative Seal treatment.
Reclamite Preservative Seal will seal out moisture and rejuvenate the asphalt to help maintain the pavement in a near new condition by restoring the asphaltenes and maltenes balance. Asphalt pavement becomes pliable again as the Reclamite fluxes with the asphalt cement, healing minor cracking and restoring the aggregate/asphalt bond. Reclamite Preservative Seal will preserve an asphalt pavement at one-half to one-third the cost of other conventional
treatments.

Reclamite is a spray-on application typically diluted one or two parts Reclamite to one part water. The rate and proportions may vary according to pavement absorption and application needs. In critical areas such as airfields, a core sample can be taken for lab analysis to determine pavement absorption. Reclamite will penetrate down from the surface (the major area of damage) with depth depending on the application rate and the surface porosity. Normally a treatment will last for 3-5 years before another application is required. A small amount of sand is applied, after the Reclamite has had time to be absorbed, to address skid resistance.

On aging pavements, Reclamite rehabilitates and rejuvenates by restoring physical properties of the asphalt. Reclamite is also recommended for new asphalt pavements as a construction seal to significantly extend pavement life.

CLICK HERE to contact us for more information on Reclamite rejuvenating agent